Whiting Hackle Guage Blue

ID: whgb

Highest quality: machined and anodized aluminum * Revolutionary: "nail-head" post design prevents hackle from slipping off * Unique: oval hole holds gauge at a comfortable viewing angle on pedestal post * Easy on the eyes: measure hackle within the bar widths, not to a line * Designed to fit most popular 3/8" diameter fly tying vise shanks * Extremely accurate and consistent measurements with lasered scale * Each measurement has a dark and light bar to easily see any color of hackle * Goes down to size 28 (the diameter of the nail-head pin is size #28) * Goes up to size 8 (the width of the entire hackle gauge is size #8)

Tiewell Dubbing Needle

ID: 264520

The Tiewell dubbing needle is made from hexagonal brass rod and has a stainless steel needle inserted in the end. An inexpensive, yet well made Australian made tool that will provide years of service.

Tiewell Dubbing Teaser

ID: 264530

The Tiewell dubbing teaser is of similar construction to the dubbing needle except the latter has been replaced by a multibarbed stainless steel rod. When brushed against the dubbing it catches on any loose fibres and teases them from the fly body. A very useful and yet inexpensive tool.

Tiewell Bobbin Threader

ID: 264560

The Tiewell bobbin threader is made from solid hexagonal brass rod to prevent the tool from rolling around on the tyers bench. It is an inexpensive, yet quality, Australian made tool. Black nickel plated.

Whiting Hackle Guage Ruby

ID: whgr

Whiting Hackle Guage Slate

ID: whgs

HMH Bobbin Rest

ID: hmhbr

Machined delrin support body and thread support. Machined brass fittings. Stainless rod is 9" long with 4" upright. Adjustable in three directions

HMH Profile Plate

ID: hmhpp

Seeing better means tying better. Machined delrin support body with machined brass fittings. Stainless steel rod. White plate adjusts side to side, front to back, and tilts to give optimum view of fly.

Cautery

ID: ctc

Perfect for removing loose fibers or burning deerhair or wool to inlay eyes. Battery operated with changeable tip and battery.

Replacement Cautery Tip

ID: ctip

C&F 3-in-1 Dubbing Brush / Needle

ID: cft70

Dyna-King Trim Bag 3" Standard

ID: 3trim

All Dyna-King Trim Bags mount directly under the vise on the shaft to better catch clippings. They are designed for convenient emptying. Simply grasp frame near mounting tab, and pull the bag away. Made of soil resistant nylon. Impervious to most head cements. Available in 3"for conventional vises and also in "extended wire" for the rotary vises.

Dyna-King Gray Square Profile Plate

ID: dk10

Dyna-King's Profile Plates reduces glare and clutter. Fully adjustable, and can fit any standard 3/8" shaft.

Dyna-King Gallows Tool

ID: dk11

The Gallows Tool has been around for a very long time, and it is because it has been time tested and proven. Acts like a third hand. Used primarily for tying of parachute flies. Spring maintains tension on either the tying thread or on the post, as you wind your hackles. Very simple to use. Fully adjustable. Stainless Steel and Black Delrin construction. Provides maximum work area. Easy take down for travel.

HMH Starter Tube Fly Tool

ID: hmh3

Will work in any vise. This tool converts your vise into a tube fly vise and makes tying tube flies easy. The kit comes with two stainless steel pins that fit the most popular tube sizes, plus two each HMH custom cut to length large and small, junction tubing and instructions.

Flyworld

Fly Tying Accessories